13.5.3. Removal and installation of a front bumper

Front bumper

1 — Two bolts, 23 Nanometers
2 — the Air lattice
3 — the Screw
4 — the Level. It is fixed by means of a bilateral adhesive tape. Therefore at removal collapses
5 — the Bumper
6 — the Guide

7 — Six clips
8 — Two plugs
9 — bumper Shock-absorbers
10 — the Wing
11 — the Special nut
12 — Loker
13 — Two screws

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study the Section Removal and installation of plafonds of internal lighting.

  1. Mark on tires with shooters the direction of their rotation. Weaken bolts of fastening of a wheel. Lift and establish a forward part of the car on supports and remove wheels.
  2. Remove in front the lower cover of the engine, address the Section Removal and installation of the top cover of the engine / the lower protection of a motive compartment / stretcher.

Some types of works are carried out as from the left and spravy side. However they are described for one of the parties of the car.

  1. Turn out bolts from below and disconnect a loker in a forward part from a bumper, and also from a cross-piece.
  1. Wring out a loker (arrow A) and turn off a bolt (2) and nuts (1).
  1. Remove a side part of a bumper (arrow B).
  1. Take away the screw-driver lock levels with (1) on (4) (an arrow on an accompanying illustration), disconnect a lattice and take out from a bumper.
  1. Turn out the bolt (1) which is behind, address an illustration the Front bumper.
  2. Pull a bumper forward.
  3. Remove a hose of a faroomyvatel if it is available.

Substitute capacity for collecting the following water.

  1. Disunite all sockets going to a bumper.
  2. By means of the assistant remove a bumper from shock-absorbers of collision (9) forward.

Installation

 PERFORMANCE ORDER

  1. Check whether carving pins on each side of a bumper are established, and also clips (7) and plugs (8) in wings, address an illustration the Front bumper.
  2. Installation is carried out in the sequence, the return to removal. At the same time fix a bumper to collision shock-absorbers by the moment of 23 Nanometers. You watch that carving pins from sides of a bumper entered openings on a wing.
  3. Fix wheels, observing the direction of their rotation. Lower the car on wheels and only after that tighten cross-wise bolts of fastening of a wheel the moment of 120 Nanometers.
  4. Attach a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.