13.5.13. Removal and installation of a door

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

  1. Completely lower a window and open a door.
  2. Remove facing of a door, address appropriate section.
  3. Disunite the socket and extend wires from a door.
  1. Squeeze out a cover of a cable (1) from a door.
  1. Ask the assistant to hold a door. Turn out screws of fastening of loops of a door (2) below and above.

On an illustration the lower loop of a forward door is shown.

  1. Remove a door and put it on the soft basis.

Installation

 PERFORMANCE ORDER

  1. Establish into place a door by means of the assistant and screw screws of fastening of loops, without tightening them.
  2. Weaken a door lock clamp, close a door and check a gap on a door prileganiye contour. If necessary, adjust a door, address appropriate section.
  3. Tighten screws of fastening of loops the moment of 32 Nanometers.
  4. Further installation is carried out in the sequence, the return to removal.
  5. Attach a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.



QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE