13.5.29. Removal, installation and check of the movable panel of a roof


  1. Remove overlays of the movable panel, address the Section Removal and installation of an overlay of the movable panel of a roof.
  1. Turn out on both sides screws.
  1. Remove the panel upward.



  1. Install into place the movable panel and fix it by screws.
  2. Establish slips.



  1. For an exception of emergence of noise under the influence of wind the movable panel has to be installed on height according to given sizes.

Close at the same time the movable panel from its back situation, but not from the top situation.

  1. Check adjustment on height on the edge of cut radiuses in a roof in relation to the center of the car. The panel should not be in a forward part above, and behind below than a roof.