Audi:: A4 B6:: Removal and installation of a rear bumper

13.5.7. Removal and installation of a rear bumper

Instruction: Removal and installation on the Sedan models is carried out similarly. Unlike the Station wagon models there are no basic and sealing levels (7), (9), and also a support (14).
1 — Two bolts
2 — Loker of a wing
3 — the Nut
4 — the Nut
5 — the Guide
6 — Six clips
7 — the Basic level
8 — the Bolt

9 — the Sealing level. It is inserted into a bumper
10 — the Decorative level. It is inserted into a bumper
11 — the Side sealing level. It is inserted into a bumper
12 — the Bumper
13 — Two bolts
14 — the Support. At installation of a new bumper it has to be replaced.
15 — the Shock level
Instruction: The shock level is fixed on a rear bumper by a bilateral adhesive tape. Thereof at removal it collapses.

Versatile person

Removal

PERFORMANCE ORDER

Disconnect a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

Some operations are carried out as from the left, and spravy party of the car. The description them is given only concerning one party.

Remove side facing in a cargo compartment, address the Section Removal and installation of facings (Station wagon).
Disunite the loudspeaker socket behind side facing and disconnect a loudspeaker together with the amplifier.
Disunite the socket of parking sensors at the control unit under a back lamp.
Turn off nuts (3) and nuts (4) in a cargo compartment.
Turn out bolts (13).
Disconnect a loker of a wing in a back part.
Turn out a bolt (1) at a guide (5) and remove a side part of a bumper.
By means of the assistant pull a bumper back and remove it.

Installation

PERFORMANCE ORDER

Installation is carried out in the sequence, the return to removal.
At installation of a new bumper establish from below a new support (14). Then release a support, having pulled for thread. Thus the support unloads and holds a bumper in relation to a cross-piece.

The support is released when the bumper is completely established.

Attach a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.