13.5.28. Removal and installation of moldings
|
|
Moldings are pasted to a body and at their removal collapse. |
Removal
|
|
- Heat parts moldings (1) and (2) hair dryer and separate them from a door.
|
|
|
Installation
|
|
- Clear the place where the level will be pasted, gasoline, process a silicone eliminator and dry.
|
|
Moldings should be pasted only at the room temperature. For this purpose the car and levels at least in two hours prior to gluing have to be placed indoors with room temperature. |
- Remove a protective film (3) with a bilateral adhesive tape (4). Insert a molding pins into openings on a door and paste.
- Heat a molding the hair dryer to temperature of 40 °C and strongly press or roll.
|
|
After a prikleyka of moldings you hold the car within four hours at the room temperature. |
|
|
Molding of the lower beam
Removal
|
|
- Turn out screws (3) and put forward a forward molding (1) from holders back.
|
|
|
|
Similarly remove a back molding (2). |
|
|
Installation
|
|
- Establish a molding on the lower beam, move forward in holders and fix by screws.
|
|