13.5.37. Removal and installation of the lever of a cleaner of back glass

 PERFORMANCE ORDER

  1. Stop a screen wiper in extreme situation.
  1. Mark the provision of a brush on glass, for example, by means of an adhesive tape.
  1. Carefully hook and uncover (4) a cleaner axis up.
  1. Carefully remove a jet (3) from a connecting tube.
  1. Weaken a nut (2) and remove the lever (5) from an axis. (6) – brush.

Installation

 PERFORMANCE ORDER

  1. Check that the electric motor of a screen wiper stood in extreme situation. If necessary, quickly start the electric motor and stop it the switch.
  2. Install the lever on an axis of a screen wiper and you will expose it by means of the tag put at removal. It is also possible to expose the lever on distance between a brush and the lower edge of glass, having measured it from the right top of a cleaner. Adjusting size: from 15 to 20 mm.
  3. Screw a nut and tighten it by hand.
  4. Check extreme position of the lever, if necessary, again adjust.
  5. Tighten a nut the moment of 12 Nanometers and close it a cover.