13.5.17. Removal and installation of the electric motor of the drive of a window regulator

The electric motor of the drive of a window regulator can be removed and installed in any position of the electric motor or flew down.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

  1. Remove a door upholstery, address appropriate section.
  1. Disunite the window regulator control unit socket.
  1. Turn out 3 bolts (2) and remove from a door the electric motor of the drive of a window regulator (1).

Installation

 PERFORMANCE ORDER

  1. Install the electric motor on carving pins (3), screw bolts and tighten them the moment 3.5nm. At the same time you watch that entered the panel of a door (arrow).
  2. Join the socket of a window regulator and establish into place a door upholstery, address appropriate section.
  3. Attach a negative cable (-) of the rechargeable battery.

Observe indications of the Section Replacement of the Rechargeable Battery.

  1. Install the electric motor in a basic position: Include and again switch off ignition. Again include and lift glass against the stop up. At the same time hold the window regulator switch pressed 2 pages. Now the electric motor is correctly adjusted.