13.5.8. Removal and installation / adjustment of a cowl
Removal
|
- Open a cowl
- Disconnect a negative cable (-) of the rechargeable battery.
- Disconnect a hose and disunite the windscreen washer jet socket.
- For a possibility of the subsequent installation mark the provision of a cowl.
- Ask the assistant to take a cowl (1). The small screw-driver raise a lock spring (arrow) a little. Disconnect a gas-filled emphasis (5) from the top spherical support.
- Turn off two nuts (4) Leva and on the right and remove a cowl together with the assistant.
|
|
Installation
|
- Establish a cowl together with the assistant on a loop (2). Adjust the provision of a cowl on earlier put tag.
- Establish and record a gas-filled emphasis on a spherical support.
- Close a cowl and expose it, observing gaps, see below.
- Tighten nuts (4) the moment of 21 Nanometer.
- Installation is carried out in the sequence, the return to removal.
- Attach a negative cable (-) of the rechargeable battery.
|
|
Check/adjustment
Utilization of a gas-filled emphasis
|
|
If the gas-filled emphasis is replaced, it is necessary to produce gas from an old emphasis. |
|
- For this purpose clamp an emphasis in a vice in the area designated on an accompanying illustration (x = 50 mm).
|
|
|
Clamp an emphasis surely only and the specified area, otherwise there is a danger of accident! Then you nadpilit the cylinder at distance of one third of total length of a basic mark from a rod. For protection against emission of oil cover the region of a cut with a rag. Besides, in time a pileniye use goggles. |
|
|