Audi:: A4 B6:: Removal and installation of facing of a back door

13.5.12. Removal and installation of facing of a back door


1 — Facing of a door 2 — the Decorative level 3 — Screws, 4 pieces. 4 — the Cover 5 — the window regulator Handle, the manual drive	6 — the Screw 7 — Razzhimnaya a nut, 4 pieces. 8 — the Tightening nut, 4 pieces. 9 — the window regulator Switch Depending on the equipment.

Removal

PERFORMANCE ORDER

Disconnect a decorative level (2) from facing and remove it forward.
Turn out 4 screws (3).
Manual window regulator: Remove the handle of a window regulator (5).
Enter a plastic wedge around clips between the panel of a door and facing and remove facing from a door.
Take away facing from a frame of a door a little and disconnect a door drive cable, address the Section Removal and installation of facing of a forward door.
Disunite the socket of the switch of a window regulator (9).
Remove facing from a door frame.

Installation

PERFORMANCE ORDER

Before installation check correctness of provision of tightening nuts (8) and razzhimny nuts (7) on a door frame.
Installation is carried out in the sequence, the return to removal. At the same time pay attention that the hook shows (3) drafts upward.
Manual window regulator: Install into place the window regulator handle.
Attach a negative cable (-) of the rechargeable battery.

Window regulator handle

Removal

PERFORMANCE ORDER

Enter the screw-driver between a cover (4) and the handle of a window regulator.
Uncover the window regulator handle.
Turn out the screw (6) and remove the handle.

Installation

PERFORMANCE ORDER

Install the window regulator handle in situation "for 6 hours" (± 15 °) at the closed window on a handle axis.