Audi A4 B6 - the Repair manual and operation
1. Introduction
2. Governing bodies and methods of safe operation
3. Current leaving and service
4. Engine
5. Cooling systems, heating and air conditioner
6. Power supply systems, release and decrease in toxicity of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting
9. Automatic transmission
10. Coupling, power shafts and differential
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
14.1. Specifications
14.2. Diagnostics of malfunctions of onboard electric equipment - the general information
14.3. Rassoyedineniye of sockets
14.4. Check of the electric motor of a screen wiper
14.5. Check of the warmed back glass
14.6. Check of stoplights
14.7. Removal and installation of a sound signal
14.8. Removal and installation of sensors of the parking
14.9. Replacement of the battery of the remote control of the ignition key
14:10. Relay and safety locks
14:11. Replacement of glow lamps of devices of external lighting
14:12. Removal and installation of headlights
14:13. Removal and installation of the side repeater of turns
14:14. Removal and installation of an additional stoplight
14:15. Removal and installation of a back lamp
14:16. Removal and installation of a lamp of illumination of registration plate
14:17. Removal and installation of plafonds of internal lighting
14:18. Removal and installation of the control panel
14:19. Removal and installation of the understeering switch
14:20. Removal and installation of switches of a forward door
14:21. Removal and installation of the switch of light
14:22. Removal and installation of the switch of a window regulator in a back door
14:23. Removal and installation of the switch of a trunk lid
14:24. Removal and installation of the switch of the parking brake
14:25. Removal and installation of the switch of illumination of a ware box
14:26. Removal and installation of switches of the central console
14:27. Removal and installation of the radio receiver / navigation device / CD changer
14:28. Removal and installation of loudspeakers
14:29. Removal and installation of antennas
14:30. Removal and installation of the tank of liquid of the windscreen washer / electric motor of the pump
14:31. Removal and installation of the electric motor of screenwash
14:32. Removal and installation of the electric motor on back glass (Station wagon)
14:33. The uniform lock - the general information
14:34. Removal and installation of a locking element of a cover of the fuel tank
14:35. Digital tire of data of CAN
14:36. Schematic diagrams of electric equipment
14.8. Removal and installation of sensors of the parking
PERFORMANCE ORDER
Sensors (shooters on an accompanying illustration) are located in a bumper.
On an illustration the front bumper is shown.
External forward sensors: Remove a headlight, address
the Section Removal and installation of headlights
.
Internal forward sensors: Remove a front bumper, address
the Section Removal and installation of a front bumper
.
Back sensors: Remove a rear bumper, address
the Section Removal and installation of a rear bumper
.
Disunite the socket (1) of the sensor.
Press 2 lock plates (shooters) aside and squeeze out the sensor outside from a bumper.
Installation
PERFORMANCE ORDER
Installation is carried out in the sequence, the return to removal.