14:15. Removal and installation of a back lamp

 PERFORMANCE ORDER

  1. Open an opening (1) in facing of a luggage carrier.
  1. Turn out the screw (3) and cast away a back lamp outside, having taken out at the same time from a wing a spherical finger.
  1. Disunite the socket on the lamp panel.

Installation

 PERFORMANCE ORDER

  1. Join the socket on the lamp panel.
  1. Establish a back lamp on a body so that fingers were pressed into plugs (7). At the same time you monitor the correct provision of consolidation.

    1 — the Dimensional lamp
    2 — the Stoplight / a dimensional lamp
    3 — the Index of turn back
    4 — a backing Lamp
    5 — the Foggy lamp
    6 — the Connecting plug
    7 — Plugs

  1. Tighten the screw (3) the moment of 6 Nanometers.
  1. If it is necessary, turn off a nut (2) and you will expose a back lamp so that to provide a uniform gap in relation to adjacent parts of a body. Tighten a nut the moment of 12 Nanometers.

Replacement of glow lamps

 PERFORMANCE ORDER

  1. Squeeze 2 lock levels (shooters) and remove the lamp panel from a back lamp.

    1 — the Dimensional lamp
    2 — the Stoplight / a dimensional lamp
    3 — the Index of turn back
    4 — a backing Lamp
    5 — the Foggy lamp
    6 — the Connecting plug
    7 — Plugs

  1. Press lamps with (1) on (5) into cartridges, turn and take out. Replace lamps with new.

If the backing lamp lamp after replacement after all does not burn, it is necessary to check the switch. The switch is at the check point over a flange of a power shaft.

Versatile person

Removal

 PERFORMANCE ORDER

  1. Open a door of a back and take out a cap from facing.
  1. Turn out a bolt (1). Cast away a back lamp outside, having taken out at the same time a spherical finger from a wing.
  1. Disunite the socket of the lamp panel.

Installation

 PERFORMANCE ORDER

  1. Join the socket of the lamp panel.
  1. Establish a back lamp on a body so that fingers were pressed into epiploons (6). At the same time you monitor the correct provision of consolidation.

    1 — the Foggy lamp
    2 — the Index of turn back
    3 — a backing Lamp
    4 — the Stoplight / a marker light
    5 — the Connecting plug
    6 — Plugs for fingers

  1. Tighten the screw (1) the moment of 6 Nanometers.
  1. If it is necessary, turn off a nut (2) and you will expose a back lamp so that to receive a uniform gap in relation to adjacent elements of a body. Tighten a nut the moment of 12 Nanometers.

Replacement of glow lamps

 PERFORMANCE ORDER

  1. Press four lock levels outside of (shooters on an accompanying illustration) and remove the lamp panel from a back lamp.
  1. Press glow lamps with (1) on (4) into cartridges, turn and take out. Replace lamps with new.

    1 — the Foggy lamp
    2 — the Index of turn back
    3 — a backing Lamp
    4 — the Stoplight / a marker light
    5 — the Connecting plug
    6 — Plugs for fingers

If the backing lamp lamp after replacement after all does not burn, it is necessary to check the switch. The switch is at the check point over a flange of a power shaft.