3.14. Check of level of oil of automatic transmission
|
|
- Liquid level is measured in automatic transmission at the heated-up engine and the transmission. For warming up of the power unit up to the necessary temperature you can make short (15 kilometers) a trip.
- Place the car on a horizontal surface, reliably tighten the emergency brake. For reliable fixing of the car enclose under prop wheels.
- Start the engine and leave to work at single turns. Press a pedal of a brake and accurately move the selector from situation P to situation 1, then back to the River.
|
|
5-staged automatic transmission 01V
|
|
- Turn out a stopper of a jellied opening (the shooter on an accompanying illustration).
|
|
- Check oil level. Level of oil has to reach the lower edge of a jellied opening.
- Tighten a stopper of a jellied opening (shooter) the moment of 30 Nanometers, having established a new sealing ring.
|
- Turn out at the check point a stopper of a jellied opening at the left (an arrow on an accompanying illustration).
|
|
- Check oil level. Level of oil corresponds to the required value if it does not reach 8.5 mm a jellied opening.
- Tighten a stopper of a jellied opening the moment of 20 Nanometers.
|
|
Behind on a cowl there can be a sticker with marking and date of replacement of oil. Enter new data in a sticker or make new. |
|
|
If oil level too low, check the check point for tightness, if necessary, repair (work HUNDRED). It is only not enough to fill in oil in the check point. It is necessary to watch its correct level! It is not necessary to fill in too much oil at all. |
- Establish into place the lower cover of a motive compartment, address the Section Removal and installation of the top cover of the engine / the lower protection of a motive compartment / stretcher.
- Lower the car on wheels.
|
|