13.6.21. Removal and installation of a back seat
|
|
- Strong breakthrough disconnect a seat (arrow A) from holders (1), raise it and pull back (an arrow B on an accompanying illustration).
|
|
- Take out the plug of a side safety cushion from a groove at a back wall of a pillow of a back seat remove a seat.
|
|
Installation
|
|
- Establish a seat into place and insert the plug of a side safety cushion into a groove in a pillow of a back seat.
- Shift a seat back, in front press in holders (1) and record.
|
|
At the same time do not damage holders. |
|
|
Back of a back seat, folding
Removal
|
|
- Cast away a back of a back seat forward.
|
- Hook and uncover behind (3) (an arrow on an accompanying illustration). Turn out the screw (1) and remove a safety collar (2).
|
|
- Lift a back (5) from a support (4) and remove from a side element of fastening (6). If necessary, again put on the plug (7).
|
- Uncover (2) at an armrest (1) in the direction of an arrow.
|
|
- Turn out the screw (3).
- Take out a finger (4) from a loop (5) and take out an armrest.
|
|
Installation
|
|
- Installation is carried out in the sequence, the return to removal.
|
|
Back of a back seat, motionless
Removal
|
|
|
|
- Remove a back seat.
- Take out head restraints from backs.
- Take out guides for head restraints from backs. At the same time insert the small screw-driver obliquely through an opening at a guide, press the screw-driver inside, release a stopper and take out a guide from a back.
- If necessary, take out from a back a bag frame for skis.
-
Models with a side safety cushion: To exclude operation a head safety cushion, switch off ignition and disconnect at first negative, and then positive cables of the rechargeable battery. Instructions are provided in the Section Replacement of the Rechargeable Battery.
-
Models with a side safety cushion: Disunite the safety cushion socket.
|
- Take out a back (1) upward from collars (2) fastenings (3).
|
|
|
Installation
|
|
- Installation is carried out in the sequence, the return to removal.
|
|
During connection of the rechargeable battery in salon there should not be people. |
- Shoot the insulating film from the negative plug of the rechargeable battery, attach at first positive (+), and then a negative cable (-) to the rechargeable battery.
|
|
Side pillow of a back seat
Removal
|
|
|
|
- To exclude operation a head safety cushion, switch off ignition and disconnect at first negative, and then positive cables of a battery room
- Remove a back seat.
|
- Turn out the screw (6).
|
|
- Models with a side safety cushion: Press a lock level and disunite the safety cushion socket.
- Turn off a nut (4), turn out an anchor bolt (5) and remove a side pillow (1). (2) - a dish-shaped washer, (3) – a washer.
|
|
Installation
|
|
- Installation is carried out in the sequence, the return to removal. At the same time adjust an anchor bolt and tighten a nut the moment of 55 Nanometers. Tighten the screw (6) the moment of 10 Nanometers.
|
|
During connection of the rechargeable battery in salon there should not be people. |
- Models with a side safety cushion: Shoot the insulating film from the negative plug of the rechargeable battery, attach at first positive (+), and then a negative cable (-) to the rechargeable battery.
- If after inclusion of ignition the safety cushion signaling device on the control panel does not die away, it is necessary to consider information from memory of malfunctions on HUNDRED.
|
|