5.1.9. Removal and installation of the pump of cooling liquid

Laying and sealing rings are surely replaced.

The lower cover of a gear belt is not removed. The gear belt remains on a pulley of a bent shaft. For protection against hit of cooling liquid close a gear belt.

 PERFORMANCE ORDER

  1. Close a gear belt before removal of the pump of cooling liquid a rag to exclude hit on a belt of cooling liquid.
  2. Merge cooling liquid, address appropriate section.
  3. Take off maple a belt, address the Section Removal and installation of a belt of the drive of auxiliary units.
  4. Unscrew three screws of fastening of a tension element.
  5. Remove the top and central cover of a gear belt, address the Section Removal and installation of a gear belt.
  6. Take off a gear belt from a wheel of the pump of cooling liquid, address the Section Removal and installation of a gear belt.
  1. Turn out bolts (arrows on an accompanying illustration) and take out the pump of cooling liquid from the block of cylinders.

Installation

 PERFORMANCE ORDER

  1. Moisten a new sealing ring (3) with cooling liquid and insert it into the block of cylinders.
  1. Insert the pump into the block of cylinders and fix it by bolts (1) the moment of 15 Nanometers.
  2. Establish a gear belt and adjust gas distribution phases, address the Section Removal and installation of a gear belt.
  3. Establish a tension element of a maple belt and fix by its moment 25 Nanometers.
  4. Establish maple a belt, address the Section Removal and installation of a belt of the drive of auxiliary units.
  5. Fill system with cooling liquid. Address the Section Replacement of Cooling Liquid.