12.3. Suspension bracket of back wheels

1 — the Shock-absorber
2 — a suspension bracket Beam
3 — the Screw spring
4 — the Brake disk

5 — the wheel Bearing
6 — the convergence adjustment Mechanism
7 — the Mechanism of adjustment of disorder

Suspension bracket levers. Models with the forward drive

1 — the Trapetsiidalny lever. At damage of support replace the lever
2 — the Eccentric screw, provides adjustment of a convergence. No more than 90 turn away to the left and to the right on a corner °
3 — the Eccentric washer
4 — the Nut *, 95 Nanometers
5 — the Combined screw *
6 — a spring Support lower
7 — the Screw spring
8 — a spring Support top
9 — a spring Support top, only for the running gear intended for bad roads
10 — the Combined screw *, 85 Nanometers + 90 °
11 — the Cross lever
12 — the Eccentric screw. Provides adjustment of disorder, no more than 90 turn away to the left and to the right on a corner °

13 — the Washer
14 — the Nut *, 85 Nanometers + 90 °. Self-stopped, when tightening bolts the car has to stand wheels on the earth.
15 — Cross draft
16 — the Guard for protection against hit of stones, only for the running gear intended for bad roads
17 — the Nut with a fillet *, 85 Nanometers + 90 °. At an inhaling the car has to stand wheels on the earth
18 — the Guard for protection against hit of stones, only for the running gear intended for bad roads
19 — the Bolt with a fillet, 25 Nanometers
20 — the Holder of a cable of the drive of the parking brake
* surely replace

Shock-absorber, fist and nave of a wheel

1 — the Fist, models with the forward drive
2 — the Nave with the wheel bearing. Repeatedly apply only in case the block is removed manually. Otherwise it needs to be replaced in a set. The bearing and a nave are located in one case. The bearing a wheel/nave do not demand service. Adjustment or repair are not made
3 — the Bolt with a fillet
4 — the Boot
5 — the wheel speed Sensor

6 — the Screw with an internal hexagon, 10 Nanometers
7 — the Nut, 150 Nanometers + 90 °. Replace. At an inhaling the car has to stand on wheels
8 — the Washer
9 — the Shock-absorber
10 — the Combined bolt, 36 Nanometers
11 — the Combined bolt

The suspension bracket of back wheels is equipped with trapezoidal levers. The beam of a suspension bracket is made of steel, trapezoidal levers - from the hollow aluminum shape. Such design is characterized by the insignificant weight and compactness. Thanks to it becomes possible to reach both at front-wheel option, and at the four-wheel drive of a low arrangement of a floor in a luggage carrier and the optimum width of a cargo compartment.

All lever elements through rubber-metal support are connected by hinges to elastically established suspension bracket beam that provides effective clearing of vibrations of a body. Podressorivany a back suspension bracket it is carried out by screw springs and two shock-absorbers which are located separately and easily act.

Carrying out welding and leveling works on the bearing and directing elements of a forward suspension bracket is not allowed. The self-stopped nuts, and also rusty bolts / nuts, when carrying out repair have to be replaced.