7.4.9. Removal and installation of the regulator tension / replacement of brushes

 PERFORMANCE ORDER

  1. Remove the generator, address appropriate section.

Depending on model removal of the regulator is possible also on the installed generator.

  1. Turn off nuts on connecting plugs.
  2. Turn out screws and remove a protective cover from the generator.

Depending on model generators of various executions can be installed.

  1. Turn out screws and take out the regulator aside.
  2. Replace brushes for what unsolder a rope.
  3. Check wear of rings, if necessary pierce them and polish (work HUNDRED).
 

Installation

 PERFORMANCE ORDER

  1. Insert new brushes (A) and springs (V) into the brush holder (C) and solder contacts.
  1. To exclude hit of solder in a rope at the soldering, clamp a brush rope flat-nose pliers.

At solder hit ropes become rigid and brushes unsuitable for work.

  1. Install into place the regulator of tension and fix it.
  2. After installation of new brushes check them for ease of the course.
  3. Fix a protective cover on the generator.
  4. Screw nuts on connecting plugs.
  5. Install into place the generator, address the Section Removal and installation of the generator.