10.2. Power shafts of wheels

1 — the Bolt, surely replace
2 — the Collar, surely replace
3 — the Protective cover of the external hinge. Check for existence of cracks and places of mastications. Before fixing of collars quickly raise a cover to level pressure
4 — the Collar, surely replace
5 — the Screw with an internal polyhedron
6 — the Hinge
7 — the Star of "Tripode" with rollers. The facet (arrow) indicates shaft vents
8 — the Lock ring, surely replace
9 — the Round sealing ring
10 — the Cover

11 — the Collar
12 — the Protective cover of the Tripode hinge. Before fixing of collars quickly raise a cover to level pressure. The hinge at the same time has to be in the central situation
13 — the Shaft
14 — the Lock ring. Surely replace the Lock ring insert into a shaft groove.
15 — the External hinge. Replace only in a set. On a shaft is established by means of the plastic hammer so that the lock ring was recorded.
Attention: When replacing a cover, if necessary, to fill the hinge with lubricant. Pay attention to distinction in lubricant grades depending on diameter of the hinge.
*) six-sided case

Power shaft with the hinge of equal angular speeds

1 — the Bolt, surely replace
2 — the External hinge of equal angular speeds, replace only in a set
3 — the Lock ring. Surely replace. Before installation of the hinge it is inserted into a shaft groove. If the hinge is installed, the ring is not visible
4 — the Collar
5 — the Cover of the external hinge. Check for existence of cracks and places of mastications. In the presence of damages of the hinge check it outside. Before fixing of collars quickly raise a cover to level pressure. Before fixing of collars quickly raise a cover to level pressure. Sealing surfaces at installation of covers have to be cleared of lubricant
6 — the Shaft
7 — the Cover, surely replace

8 — Consolidation, surely replace
9 — the Lock ring. Surely replace. It is inserted into a shaft groove
10 — the Internal hinge. Replace in a set. Surfaces under glue have to be cleared of lubricant and oil
11 — Podkladnaya a plate
12 — the Screw with an internal polyhedron
13 — the Cover with a cover. In the presence of damages check the internal hinge. Check a cover for existence of cracks and places of a mastication. Replace only in a set. Sealing surfaces at installation have to be cleared of lubricant and oil

The car is set in motion by means of torque transmission from the transmission to wheels by means of two (or four – on models with the four-wheel drive) power shafts. Boots of internal hinges are made of rubber, and external — of thermoplastic (thermoplastic is steadier against external influences). Each shaft consists of three main parts: internal hinge (tripod type), directly shaft and external hinge of equal angular speeds (HEAS). The internal hinge of a shaft is fixed by means of a lock ring. External hinges of both shaft (CV JOINTS) terminate in shlitsevy shaft which enter vents of naves of driving wheels. Shaft are fixed in naves by nuts.